A&D OP-05 Spécifications télécharger pdf (Page 70)

HOW TO USE THE COMMAND MODE

In the command mode, a “command” is transmitted from an external unit to the AD-4401, the AD-4401 operates in

compliance with the command and responds with a result. When the command is not accepted due to an error

(improper command or faulty data), a “negative acknowledgment” is made. The communication procedure differs

depending on the command.

Command Name Function Com. Procedures

RW (Request Weight) Reads the weight B

RB (Req. Batch status) Reads the weighing sequence status B

RF (Request Final) Reads the weighing(loading) result B

RT (Request Total) Reads the accumulated weight and times B

DT (Delete Total) Clears the accumulated value A

MG (Make Gross) Displays the gross A

MN (Make Net) Displays the net A

MZ (Make Zero) Clears to zero A

MT (Make Tare) Subtracts the tare A

CT (Clear Tare) Clears the tare A

BB (Begin Batch) Starts batching A

BD (Batch Discharged) Starts discharging A

HB (Halt Batch) Emergency stop A

SS (Set Setpoints) Sets the setpoints C

RS (Request Setpoint) Reads the setpoints to be used. B

RE (Read EEPROM)

Reads from the EEPROM.

Note: Accepted only in the calibration mode

WE (Write EEPROM)

Writes to the EEPROM.

Note: Accepted only in the calibration mode

* RE and WE commands are accepted only in the calibration mode. (Step 2 state in 5-2)

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 89 90

Pas de commentaire

A&D OP-05 Spécifications Page 70