A&D OP-05 Spécifications télécharger pdf (Page 13)

CHAPTER 3 INSTALLATION AND CONNECTIONS

This chapter describes the installation environment, and connections to the power terminals and load cell connector. For

other external inputs/outputs, see their relevant descriptive chapters.

Control I/O, Setpoint (SETPOINT), Standard serial output (SER. OUT) —— Chapter 8

Options —— Chapter 9

3-1 ENVIRONMENT

This is a precision electronic instrument. Handle it very carefully. The

working temperature range is -5 to +40°C. Install it in a place free from

the direct sunlight. When water drops may splash over the

instrument, attach it to a control panel, using the accessory

packing. This makes the instrument's front panel splash-proof.

3-2 POWER SUPPLY

1) Prior to connecting the power source, read this manual thoroughly.

2) Be sure to earth ground the instrument. Use independent grounding if possible. Try not to share grounding with

other electric devices that create electrical noise.

3) The power source should be either 100 to 120 VAC +10%/-15% specification, or 200 to 240 VAC +10%/-15%

specification; with a frequency of 50 or 60 Hz. Use a stable power source free from instantaneous dropout or

noise. Sharing a power line could result in malfunctioning.

4) The load cell output is very weak. Do not install any noise-generating device near the load cell or the load cell

cables.

5) Each input/output cable should be shielded and connected to either shield terminal 7 or 10 of the terminal strip on

the rear of the indicator. Use of terminal 11 or the indicator body, could induce electrical noise.

Terminal No. Terminal Function

1 EXC+ Load cell excitation voltage (+)

2 SEN+ Sensing input (+)

3 SEN- Sensing input (-)

4 EXC- Load cell excitation voltage (-)

5 SIG+ Load cell input (+)

6 SIG- Load cell input (-)

7 SHLD Shield

Load cell Connections

8 A+ 4 to 20 mA output (+)

9 A- 4 to 20 mA output (-)

10 SHLD Shield

OP-07

11 E FG

12 AC AC power supply

13 AC AC power supply

,0938

,017694

+<623 -068

/0;53:

.1:3=

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 89 90

Commentaires sur ces manuels

Pas de commentaire

A&D OP-05 Spécifications Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle A&D OP-05