A&D OP-05 Spécifications télécharger pdf (Page 18)

SETTING WITH THE KEY SWITCH (SPF-01 = 0)

This method sets the setpoint using only the keys on the front panel.

Step 1 Press the [SETPOINT] key in the normal mode. The indicator will switch to the setpoint setting mode.

The “-” mark above FINAL in the Subdisplay section blinks and a final value is displayed.

• Operating the [SETPOINT] key allows you to refer to other setpoints.

• Operating the [<] or [>] key also allows you to refer to the setpoint.

• If the [SETPOINT] key is pressed while the right end (ZERO RANGE) is being displayed, you will be

returned to the normal mode.

• Pressing the [ESC] key returns you to the normal mode at any time.

Step 2 Press the [ENTER] key. The blank digits of the Subdisplay section are filled with the character “0”.

A cursor appears at the lowest digit and the right most digit starts blinking.

Step 3 Rewrite the set value, using the [<], [>], and [ V ] keys

• In this example, the set value has not been saved internally.

• When you want a negative set value in Check Weighing, and so on, move the cursor to the left end and

use the [ V ] key to decrement 0.

Step 4 Press the [ENTER] key. The set value is saved internally. Surplus zeros and the cursor disappear.

• This state is the same as in Step 1.

• To return to the normal mode, press the [ESC] key.

SETTING WITH A 5-DIGIT THUMBWHEEL SWITCH (SPF - 01 = 1)

In the normal mode, the 5-digit thumbwheel switch is read as the final value in real time. Using this thumbwheel switch,

you can set other setpoints.

When the setting of the minimum graduation (CALF-03) is 10 or more, the value of the thumbwheel switch is multiplied by

10 when saved.

Step 1 Press the [SETPOINT] key in the normal mode. The indicator will switch to the setpoint setting mode.

The “-” mark above FINAL in the Subdisplay section blinks and a final value is displayed.

• Operating the [SETPOINT] key allows you to refer to other setpoints.

• Operating the [<] or [>] key also allows you to refer to the setpoint.

• If the [SETPOINT] key is pressed while the right end (ZERO RANGE) is being displayed, you will be

returned to the normal mode.

• Pressing the [ESC] key returns you to the normal mode at any time.

Step 2 In this example, a free fall is set. Press the [SETPOINT] key. The “-” mark above FREE FALL blinks and

a free fall value is displayed.

Step 3 Change the thumbwheel switch to the desired value and press the [ENTER] key. The value of the

thumbwheel switch is saved internally as the free fall.

• This state is the same as in Step 1. To return to the normal mode, press the [ESC] key.

Note: Prior to returning to the normal mode, be sure to return the value of the thumbwheel switch

to the final value.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 89 90

Pas de commentaire

A&D OP-05 Spécifications Page 18