A&D GH Series Manuel d'instructions télécharger pdf (Page 54)

A&D GR Series Instruction Manual

GB 54

2.In the specific gravity measuring mode, press and hold the [MODE] key to enter the mode to

set the liquid density.

Note

• In the normal weighing mode, the same procedure will activate the automatic response adjusment.

This function is not avaible in the specific gravity measuring mode.

Entering the water temperature (Ld in 0)

In the specific gravity measuring mode, press and hold the [MODE] key until the water

temperature currently set (unit: , factory setting: 25 ) is displayed. Use the following keys

to change the value.

[RE-ZERO] key Increases the temperature by one degree (0-99 )

[MODE] key Decreases the temperature by one degree (0-99 )

[PRINT] key Saves the change, displays „End“ and returns to the specific gravity measuring mode.

[CAL] key Returns to the specific gravity measuring mode without saving the change.

The relation between the water temperature and density.

Tempera-

ture ( C)

Tempera-

ture

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 70 71

Pas de commentaire

A&D GH Series Manuel d'instructions Page 54