A&D GH Series Manuel d'instructions télécharger pdf (Page 51)

English

GB 51

Transmiting All Data at One Time

1. Setup the RS-232C interface using “SiF” of the function table.

2. Press and hold the [PRINT] key until displaying rECALL and release the key.

3. Press the [RANGE] key to display out.

4. Press the [PRINT] key to enter this mode.

5. Press the [RE-ZERO] key. Then the balance displays out Go.

6. Press the [PRINT] key to transmit all data to RS-232C interface.

7. The balance displays CLEAr after the finish.

8. Press the [CAL] key to return to weighing mode.

The Data Number

When the “Data number output (d-no)” is set to “1” and the data that is stored in the balance mem-

ory is to be output, the “Data number” can be appended just before each data. This format consists

of six characters (excluding the terminator).

Deleting All Data at One Time

1. Press and hold the [PRINT] key until displaying rECALL and release the key.

2. Press the [RANGE] key several times to display CLEAr.

3. Press the [PRINT] key to enter this mode.

4. Press the [RE-ZERO] key. Then the balance displays CLr Go.

5. Press the [PRINT] key to delete all data.

6. The balance displays rECALL after the finish.

7. Press the [PRINT] key to transmit all data to RS-232C interface.

8. Press the [CAL] key to return to weighing mode.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 70 71

Pas de commentaire

A&D GH Series Manuel d'instructions Page 51