A&D OP-05 Manuel d'instructions télécharger pdf (Page 23)

AD-4406 Weighing Indicator Page 21

6. Functions

There are two parameter lists, one for the F-functions and one for CF-functions.

These functions control the indicator. The parameters of each function are stored in

non-volatile memory, and are not lost even if power is turned off.

F-functions: These parameters can always be changed and are used for

internal settings.

CF-functions: If you accept a certificated approval of the weighing instrument,

the CAL cover must be sealed. Therefore, accepting this approval,

the parameters of the CF-function can not be changed.

6.1. Changing the Function Settings

To enter the function settings, do either of the following.

1 When the display is off, press the ON/OFF key while pressing the +/- key.

2 When in the weighing mode, press both the F1 and F2 keys at the same time.

When you are in the function setting, F00 will be displayed.

Operating Item

Step 1 Select an item using the following keys.

key....... To select a digit.

key....... To select a value.

ENTER key . To display a parameter of the

selected item.

Proceed to step 2.

ESC key ...... To end the function setting and

enter the weighing mode.

CAL key ...... To switch between F-functions

and CF-functions.

Operating Parameter

Step 2 Select a parameter using the following keys.

key....... To select a digit or a sub item

(Type 2 or Type 3).

key....... To select a value or condition

ENTER key . To store a parameter and proceed to

step 1.

ESC key ...... To proceed to step 1 without

changing the parameter.

Display off

Press the ON/OFF key to turn the display off. This stores the changes.

6. Functions

F 2

ENTE

F 1

Weighing

ZERO

TARE

ZERO

TARE

F 2

ENTE

F 2

ENTE

F 1

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 60 61

Commentaires sur ces manuels

Pas de commentaire

A&D OP-05 Manuel d'instructions Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle A&D OP-05