A&D OP08 Manuel d'instructions télécharger pdf (Page 8)

4-2. Setting a weighing instrument and OP-08

(1) Setting a weighing instrument

Set the internal setting of the serial interface of the weighing instrument as follows:

This setting is the same as the factory setting.

Setting item Setting value

bPS

Baud rate

2400 bps

btPr

Data bit , parity bit

7 bit EVEN

(2) Setting an OP-08

Use “DeviceInstaller” software for setting.

Cancel the firewall function on the computer.

Step 1 Connect the computer and the weighing instrument with the OP-08 to the same network.

If multiple instruments are connected, connect one by one.

Factory setting is set at the same IP address (172.16.100.2).

Step 2 Start from the Start menu on the computer.

Click “Start”, “Program”, “Lantronix”, “DeviceInstaller” to start.

Step 3 Click “Search” to perform automatic detection of the OP-08 connected to the network.

Step 4 Click on the (+) mark to expand the parameters and select the IP address that you would

like to change as shown in the diagram below. The factory default number is 172.16.100.2.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Pas de commentaire

A&D OP08 Manuel d'instructions Page 8