A&D OP08 Manuel d'instructions télécharger pdf (Page 16)

-Sending a send data command to the weighing instrument for data acquisition.

Click the “Test” button to send the command set in the <Property> window.

If a response to the command is displayed, communication is normally made.

-Sending data from the weighing instrument by pressing the [PRINT] key on the weighing

instrument.

(When used in Key mode, Auto print mode and Stream mode.)

Press the [PRINT] key on the weighing instrument to send data.

If data is displayed, communication is normally made.

Step 2 Starting communication

Click the “Start” button to communicate.

Step 3 Data acquisition

When pressing the [PRINT] key on the weighing instrument, the data of the

instrument will be sent to the computer and displayed in each cell.

To send a command to the weighing instrument, click the “Command” button.

The set command will be sent to the weighing instrument.

(If “Repeat” is selected in the “Manual/Repeat” option, the command will be

automatically sent in every setup time.)

*Note: As a standard, the total data should not exceed 10,000.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

A&D OP08 Manuel d'instructions Page 16