A&D OP-11 Manuel d'installation télécharger pdf (Page 46)

2 Operating A&D DataManagement 07/2011

2.4 Specifying the properties of the control components

2-46 SIMATIC A&D DataManagement Client - 07/2011

• Connection to the AG

The transmission mode is selected here. Via the SINEC H1 bus or via the

AS511.

• Connection via H1

(Only activated if "Connection to the PLC" "H1" is selected.)

• Device Name:

Default "/CP_H1_1:/SCP"

This setting defines the access point to the application. The setting is

independent of "Set PG/PC interface"; this enables access to S5 hardware

via H1 as well as to S7 hardware via MPI.

• TSAP

(Transport Service Access Point) connection point between CP and CPU:

"S5_PGDIR" for a coupling via backplane bus, "S5PGCONN" for a

coupling via "monkey swing". (see CPxx manual)

• Ethernet address

6 digit Ethernet address of the CP.

Notice: The Ethernet address must be unique, specified by a configuration

tool for S5 and loaded directly into the CP (launching the CP).

• Link via the AS511

(Only activated if "Link to the AG" "AS511" is selected.)

• COM interface

Interface selection for direct coupling of AG-PG/PC.

• Password for the S5 CPU

If the S5 CPU is protected by a password, it can be entered here.

Notice: this option is not supported by all S5 CPUs.

• Project path S5D file

Reference to the STEP5 project path under which the STEP5 project

(*.S5D) is stored.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 181 182

Pas de commentaire

A&D OP-11 Manuel d'installation Page 46