A&D SV-10A Manuel d'instructions télécharger pdf (Page 78)

10-4 Configuration of the COM port

When connecting the SV-A / SV-H series to a personal computer, confirm that the COM port setting

match up.

(1) Configuring of the COM port

1 Click the START bottom → the“Setting” →

the“Control panel”.

2 Double-click the“System”

3 Click the“Hardware”

Tab, and click

the“Device Manager” .

4 Double-click the“Port (COM and LPT)”

confirm the number of the COM port.

When using the USB converter, “ATEN USB

to Serial Bridge (CM4)” is displayed.

With this example, the COM port is displayed

set to “4”. The COM port of the personal

computer is displayed as “Communications

Port (COM1)”.

With this example, The COM port of the personal computer is two. Therefore, the COM port

number that is connected to the personal computer directly is displayed as “1” and “2”.

When a personal computer has many COM ports, all of the COM ports are displayed

sequentially (Example: Communications Port (COM1), Communications Port (COM2)…)

Confirm the COM port number by the connecting position of the COM port.

(2) Setting of the COM port (Example: graphing software“RsVisco”)

1 Click the START bottom →

the“Program” → the“A&D

WinCT-Viscosity” → the“RSVisco”.

2 With “RS-232C (R)” of menu →

the“COM Port (C)”, set the COM

port described above “ (1)

Configuring of the COM port”

Conforming the COM port with the Device Manager

(Example of the COM port of the USB converter set to “9”)

Setting the COM port with the RsVisco

(Example of the COM port set to “9”)

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 101 102

Pas de commentaire

A&D SV-10A Manuel d'instructions Page 78