A&D SV-10A Manuel d'instructions télécharger pdf (Page 38)

6-4 Changing Units (For all models)

The units of viscosity available are: mPa⋅s (millipascal second),

Pa⋅s (Pascal second),

cP (Centipoise),

P (Poise).

The correlation of the units are as follows: 1 mPa⋅s = 0.001 Pa⋅s = 1 cP =0.01 P

The units of temperature available are: °C (Celsius) and °F (Fahrenheit).

The unit selected upon power-on depends on the function setting. The unit selected at the factory

before shipment is as shown below.

Model Viscosity Temperature

SV-1A/SV-1H

SV-10A/SV-10H

mmPa･s

SV-100A

SV-100H

Pa･s

°C

Use the MODE key to change units. Each time the MODE key is pressed, units are switched as below:

Note that the unit of temperature is fixed in the function setting.

SV-1A/SV-1H/ SV-10A/SV-10H

 In the function setting, mPa⋅s or Pa⋅s is selected:

 In the function setting, cP or P is selected:

SV-100A/SV-100H

Note

•While the measurement is being performed using the graphing program RsVisco, unit

changes using the MODE key is not available.

•With the function setting "fnc 1", pressing the MODE key during measurement will display

the measurement elapsed time.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 101 102

Pas de commentaire

A&D SV-10A Manuel d'instructions Page 38