A&D SK-10KWP Manuel d'utilisateur télécharger pdf (Page 5)

- 4 -

WEIGHING

Before Weighing

Automatic Power-Off Function.

If the scale is left ON and the stable indicator is displayed, the automatic

power-off function turns the power off after approximately five minutes

(factory setting). To disable or enable the function, press the [ON/OFF]

key while pressing the [RE-ZERO] key. The scale stores this setting. To

verify this, press both the [RE-ZERO] and [UNITS] keys while in the

weighing mode. (See "CALIBRATION" about the [UNITS] key.)

poff0 Function disabled poff1 Function enabled

Error Message

e Overload

----- The scale zero is out of range

lb Low battery

Calibration May be Required Before Weighing

Read “CALIBRATION” first and if necessary, calibrate your scale for

accurate weighing.

Weighing Procedures

1. Turn on the scale.

Press the [ON/OFF] key to turn on the scale. Then the scale displays

all segments for a few seconds and then 0 will be displayed.

2. Start weighing

If you do not use a container for weighing,

Press the [RE-ZERO] key to display 0 . Verify the reading is 0 .

Place objects on the weighing platform to weigh.

When the reading becomes stable, the stable indicator

is displayed.

If you use a container for weighing,

Place an empty container on the platform.

Wait for the stable indicator

to be displayed and press the

[RE-ZERO] key. Place the objects to be weighed in the container. When

the reading becomes stable, the stable indicator

is displayed.

Select the weighing unit, --- Only for the “(k)g-lb” model---

If you use the (k)g-lb model, press the [UNITS] key to select

weighing with either (k)g or lb as the unit.

Normally scales power up in lb when shipped from the factory. To

power up in (k)g, turn the scale off. Press and hold the [UNITS] key,

then press the [ON/OFF] key. The scale will start with (k)g. To return

to the original setting, repeat this instruction.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

A&D SK-10KWP Manuel d'utilisateur Page 5